Supplies
Baseball
X-acto Knife
Step 1
Cut along the seams as closely as you can without cutting the seam itself. You can trim later too, so don't stress too much.
Step 2
Tear it all off!
You should be left with this:
Step 3
Find the place where your seam starts. Easiest to look on the back for where your threads are knotted. Now cut your strand in half.
Step 4
Now cut that strand in half so you have 2 pieces (thus, two bracelets).
Step 5
Start pulling the thread at each end until you have about 3-4 inches of string.
Step 6
Cut off the extra piece of baseball BUT DO NOT CUT OFF YOUR EXTRA STRING.
Step 7
Wear it and be awesome! Tying it on works fine, but you could always get fancy and make a more permanent clasp. Eventually it's shape should shift a bit I would think as it gets more worn. We shall see.
No comments:
Post a Comment